D TYPE 2 PIN MALE SOCKET WITH 2 WIRE

D TYPE 2 PIN MALE SOCKET WITH 2 WIRE

The D TYPE 2 PIN MALE SOCKET WITH 2 WIRE is a pre-wired male power connector supplied with two wires for compatible battery, EV and equipment harness applications. ARB's current product listing identifies it as a D-TAP 2-pin male socket with two wires. It is useful where a detachable two-conductor connection is needed between a battery-side harness and equipment, and buyers may search for D-TAP 2 pin connector, 2 pin male power socket, battery connector with wire or pre-wired DC connector.

The product should be selected by its actual mating connector and wiring arrangement rather than from the name alone. Connector families that look similar can use different keying, pin geometry or current contacts. The current ARB page also contains inconsistent generic copy referring to a 2+6-pin arrangement, so only the two-wire product identity should be treated as confirmed until the physical stock or manufacturer drawing is checked.

A pre-wired connector assembly combines the connector contact, crimp or termination, conductor and strain relief into one current path. Resistance at any of these points contributes to voltage drop and heat. The safe operating current therefore depends on the exact contact design, wire cross-section, insulation class, ambient temperature and installation method. Those values should be verified on the stocked part instead of assuming a rating from another D-TAP-style connector.

Polarity control is especially important in battery systems. The two conductors should be traced and identified before connection, because wire color should not be the only verification method. A meter can be used to confirm polarity on the equipment side before the connector is mated to the battery. The connector should also be positioned so the cable is not sharply bent at the rear of the housing and the plug cannot be accidentally pulled by cable weight.

Match this connector by male/female interface, two-pin arrangement, mating key, cable length, conductor size and required installation space. For replacement work, compare the existing plug and socket directly and confirm polarity and pin assignment before connecting. If the application requires a documented IP rating, current rating or locking force, obtain the exact connector specification before approving it for production use.

Applications

• Battery pack power and auxiliary harnesses using the matching D-TAP interface.

• EV, scooter and industrial equipment wiring.

• Portable power, test equipment and battery-service harnesses.

• Low-voltage DC equipment requiring a detachable two-wire connection.

• Replacement harness work where the mating connector is already installed.

Installation Guide

Disconnect the battery before fitting the connector. Verify the two wires, polarity and conductor condition, then make the downstream terminations using the correct crimp or joining method. Provide strain relief and route the cable away from sharp edges, hot parts and moving mechanisms. Before applying load, verify continuity and polarity with a meter and confirm that the connector locks or seats fully without excessive force. Inspect the connection under initial load for abnormal heating.

Why Choose ARB Accessories?

ARB Accessories focuses on lithium-battery, EV, energy-storage and battery-pack assembly components. The catalog brings together BMS boards, connectors, insulation materials, battery wiring, terminals, fuses, enclosures, testing equipment and assembly tools. For battery builders, repair workshops and OEM buyers, sourcing related components from one specialist catalog can make specification matching and procurement easier. Final suitability should still be checked against the exact battery design, equipment model and electrical requirements before installation.