CABLE TERMINAL 2.5(6)MM RING

CABLE TERMINAL 2.5(6)MM RING

The CABLE TERMINAL 2.5(6)MM RING is an electrical cable terminal for a compatible 2.5 mm² conductor in battery, EV and electrical wiring. Selection should match conductor size, terminal geometry and the mating stud or equipment connection.

This item carries a 2.5 mm² conductor-size designation and the catalog variant '6 mm ring designation'. Current Indian seller and search terminology for comparable products includes 2.5 sq mm 6mm ring terminal, cable lug, crimp terminal and battery cable terminal. Because RING appears in the product name, the connection style is a closed ring around the mating stud; confirm the 6 mm designation on the actual stock. This size is especially relevant to BMS, relay, charger-control and auxiliary wiring.

A reliable crimp depends on conductor material, strand structure, stripped length, barrel size, die profile and tool condition. All strands should enter the barrel without being cut or folded. The mating stud must fit, contact surfaces should be clean and the fastener should be tightened to the equipment manufacturer's specified torque. Conductor cross-section alone does not establish a safe ampere rating; temperature rise also depends on insulation class, ambient conditions, duty cycle, terminal material and joint resistance.

Start with the actual 2.5 mm² conductor, then match the barrel, tongue geometry and mating stud used on the battery terminal, busbar, fuse, controller, inverter or distribution block. Keep the '6 mm ring designation' designation when replacing an existing part because similar terminals can differ in hole diameter and barrel dimensions. Do not substitute terminal materials only by appearance. Use a crimp die intended for the terminal family and add heat-shrink or insulation where the system design requires it.

Applications

• BMS sense, auxiliary and low-current battery-pack wiring

• EV control harnesses and battery accessory circuits

• Electrical control panels and compact distribution assemblies

• Charger, relay, indicator and monitoring-device terminations

• Repair, prototyping and replacement of compatible wire terminations

Installation Guide

Isolate the circuit. Cut and strip the conductor cleanly, keep all strands intact, insert the wire fully and crimp with the correct die. Inspect the compression for full engagement. Fit the terminal to the correct connection point using the specified hardware and torque, then route the cable so vibration and bending are not concentrated at the crimp. Before energizing, verify polarity, continuity and mechanical tightness.

Why Choose ARB Accessories?

ARB Accessories supplies cable terminals, battery wiring components, BMS accessories, connectors, busbars, fuses and silicone wire for Indian battery pack builders and service teams. Sourcing compatible electrical hardware together can simplify assembly and replacement planning. Always match the exact terminal variant to the conductor and mating hardware.