64V 30AMP 20S 2P Lfp Battery Pack for E Scooter

64V 30Ah 20S2P LFP Battery Pack for E-Scooter

The 64V 30Ah 20S2P LFP Battery Pack is a rechargeable lithium iron phosphate battery for compatible electric scooters and light electric vehicles. It combines a 64V nominal platform with 30Ah capacity for everyday mobility, replacement installations and new vehicle builds.

This pack uses twenty cell groups connected in series, with two cells connected in parallel within each group. The series arrangement establishes the battery voltage, while the parallel arrangement contributes to its capacity. LiFePO4 chemistry makes this pack relevant to scooter designs built around an LFP charging system. Its integrated battery management system supervises operating conditions and provides electrical protection during charging and vehicle use.

Using 3.2V nominal LFP cells, twenty series groups produce approximately 64V nominal pack voltage. Multiplying 64V by 30Ah gives about 1.92kWh of nominal energy. This figure helps compare storage capacity, while usable energy depends on the permitted voltage window, battery condition, temperature and load.

The 30Ah capacity describes stored charge. Maximum continuous discharge and acceleration current depend on the cells, BMS, conductors and thermal design. Secure terminals and correctly sized cables help reduce resistive heating. Vehicle range also varies with rider weight, speed, gradients, tyre pressure and drivetrain efficiency.

Match the scooter to a 20S LiFePO4 battery system and check the controller’s permitted voltage range. Confirm the battery dimensions, mounting arrangement, discharge connector, charging socket and polarity. Select a charger approved for this pack’s LFP chemistry and charge limits. Review controller peak current and regenerative charging requirements against the BMS and cell ratings before replacing an existing battery.

Applications

• Compatible 64V LFP electric scooters

• Electric two-wheeler battery replacement

• Delivery scooter fleet maintenance

• Light electric vehicle assembly

• Prototype LFP traction-system development

Installation Guide

Switch off the vehicle, disconnect external charging equipment and verify connector polarity before installation. Secure the battery against vibration and movement, then route cables clear of sharp edges, suspension parts and heat sources. Check that the charging and discharge connections match the vehicle wiring.

Use the approved charger and complete the first charge and controlled vehicle test under observation. Inspect connectors for abnormal heating and confirm normal BMS operation. Keep protective devices in circuit and follow the pack instructions for storage and routine maintenance. Routine inspection helps maintain a consistent service record.

Why Choose ARB Accessories?

ARB Accessories supplies battery packs alongside BMS products, chargers, connectors, cable terminals, busbars and insulation materials for Indian EV builders and service workshops. Sourcing related components together can simplify battery replacement, vehicle assembly and maintenance planning. Match the pack and its supporting accessories to the vehicle specification before ordering for repeat installations.